220gsi
Member
Registered: 19th Apr 03
Location: sunderland
User status: Offline
|
just fitted a 1998 tigra engine(x16xe) into my corsa gsi (also x16xe). Went in fine with no probs but after doing a diagnostic test was showing 3 faults. 1. a fault with the knock sensor circuit.
2. wrong code for immobiliser(starts fine though. are these engines coded to the ecu in some way? i used original loom)
3. fuel pump relay low voltage. (replaced relay, cleaned terminals on fuel pump)
SOMEBODY MUST KNOW WHAT TO DO????
|
Kerry
Member
Registered: 5th Oct 01
Location: Norwich
User status: Offline
|
does resettin the ecu turn the light off and reset the codes?
|
220gsi
Member
Registered: 19th Apr 03
Location: sunderland
User status: Offline
|
DO YOU RESET THE ECU BY DISCONNECTING THE BATTERY?
|
matt_jonesuk
Member
Registered: 27th Feb 03
Location: worcester
User status: Offline
|
yea u disconnect it for bout 2 hours i think?
|
Kerry
Member
Registered: 5th Oct 01
Location: Norwich
User status: Offline
|
yes leave it off for a couple of hours
but it might be that u need tech 2 to reset it. im only sayin this kus of a problem i had with my airbag light. my mate at vx put tech 2 on and he said it was kus ecu had been messed with and just needed to reset the code and its been ok since
|
