COR54 801
Member
Registered: 24th Jul 03
Location: SCOTLAND
User status: Offline
|
 slightly worried ere guys! i have the combat 2 kit,have Flip paint on the car too(quite expensive),and was wanting to renew the front mesh as it seems old/bashed at certain areas,but when i went to a garage,for the back to be done also,they explained because it has been smoothed in(Bodykit) they cannot get into the front bumper to fit the new mesh? were they taken the PSSS or is this true?
|
COR54 801
Member
Registered: 24th Jul 03
Location: SCOTLAND
User status: Offline
|
WOOPSS!! the lowering problem i have a set of 18s " on the motor,and would like to have it lowered but not too much> any recommendations,on what/how to go about it?
|
corsa_godfather
Member
Registered: 6th May 03
Location: Greenock,Scotland
User status: Offline
|
40mm
take car in to car garage.ask to use ramps for 30mins when there quiet n fit mesh ureself from under the car
|
COR54 801
Member
Registered: 24th Jul 03
Location: SCOTLAND
User status: Offline
|
is it easy enough mate,to fit mesh...cud it be done?....wouldn't the 40mm be too low?-and cause rubbing..do u have any pics of this? what'd you think of CORSAS on 18s" ?- okay/bit daft!
|
corsa_godfather
Member
Registered: 6th May 03
Location: Greenock,Scotland
User status: Offline
|
i wouldnt fit bigger than 16s now.17s are hassle.18s are nuts.but can pull it off  with the right kit of course.
fitting mesh....easy!
cut mesh bout 2" bigger than hole all round then fold over lap on to bumper and seal on or use fibr glass
|
