daveyb
Member
Registered: 5th Nov 02
User status: Offline
|
I've got a small amp to power my speakers in the back, but...
I've already got a sub hooked up but i've two outputs so thats ok. I hooked the amp up right, earthed it well, remote is a solid connection but all i get through the speakers is fuzz, so i'm assuming its not sending a signal.
I've tried to mess with the settings on my HU but i cant seem to sort it.
Its a pioneer 6500 by the way. Any help would be appreciated.
Dave.
|
Corsa E-Tec
Member
Registered: 4th Feb 04
Location: Stevenage Drives: Leon Cupra
User status: Offline
|
if the noise gets loder as you accelerate or rev the car. i'd say the earch is not grounded properly. make sure the earth is connected to bare metal, if not, sand the paint off around the lead or connect some where else and check that your RCA's and speaker cables are on the opposite side of the car to your power and remote cables.
|
daveyb
Member
Registered: 5th Nov 02
User status: Offline
|
The earth is good cos disconnected my other amp and used same place, and never had wiring in the car when trying new amp, had all wiring outside, rca's&remote def not near power wire. Its a mystery!
|
daveyb
Member
Registered: 5th Nov 02
User status: Offline
|
NE1 else?
|