Paul_J
Member
Registered: 6th Jun 02
Location: London
User status: Offline
|
Is there any chance that 1 of my 2 cam shafts has worn itself down a bit... and thus either the air / exhaust cam isn't lifting as high as it should and thus causing the car to splutter (and sometimes almost conk out) at about 1500 rpm and also lack a lot of top end power, with the power band now trailing off at about 5100 rpm (rather than 5600 equalling peak power and the power band trailing at about 6k)?
Was suggested to me by someone the other day - and just wondered how likely it would be since my engine has only covered 54k miles and is a 1999 T reg 1.2 16v Sxi?
I have no engine management lights on and have replaced AFM's and ICV's and had no such improvement?
My top end (on the clocks has decreased greatly) - I used to be able to get 117 mph on the clocks, down hill when I made 81 bhp on the dyno... I now struggle to get 100 mph down hill!!!
Paul J
|
Anton2K3
Member
Registered: 24th Jan 03
Location: Peterborough
User status: Offline
|
I too am suffering from this problem, well, the top end thing. It is possible for camshafts to wear down, but its unusuall. It happens when the hard outer metal lining on the cams wears throught to the softer cast metal, and thus wears down failry quick. Its usually due to a failing of the outer metal, possibly manufacturing fault.
|
Paul_J
Member
Registered: 6th Jun 02
Location: London
User status: Offline
|
hmm... How do I go about getting someone to figure out what the actual problem is?
Vaux are rip off merchants and will put it on a diagnostic for £76 and tell me all is well...
Private Garage's will probably make up some bullshit and charge me a mint to get it fixed, when parts don't need changing at all and be left with a problem
|
AK
Member
Registered: 5th Jul 00
Location: Aberdeen City
User status: Offline
|
plugs ok?
|
Red_SXi
Member
Registered: 23rd Sep 02
Location: Dunstable Drives: 52 Plate BMW 3 M Sport Coupe
User status: Offline
|
When the cam wore down on one of my dads Corsa B driving school cars it made a terrible tapping noise, like an old fiesta. but that was really worn, the car still run fine though apart from the noise
|
Paul_J
Member
Registered: 6th Jun 02
Location: London
User status: Offline
|
Oh ... Mine is very tappy at the moment... but doesn't drive fine.
Plugs have been changed and checked...
|
Paul_J
Member
Registered: 6th Jun 02
Location: London
User status: Offline
|
Infact the last time I checked it the 4th cylinder was all brown and shit by the plug
The plug seemed loose and we tightened it back up...
|
Anton2K3
Member
Registered: 24th Jan 03
Location: Peterborough
User status: Offline
|
Valve seats? If the valves are not seating correctly you will lose power. Loss of compression in the cylinder? worn poston rings...but then it would smoke.
|
