topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
ok currently got my car plugged into diagnostic thing and got loads of fault codes:
these are:
1.Air idle control valve
2.Veichle rpm sensor/speed sensor
3.Immobiliser signal wrong
4.EGR - 2 codes to do with this but cant remember the exact ones
5.Quad drive sensor
can anyone shed any light on why so many have gone wrong? and wtf is quad drive??
could unichip or ecu be screwed?
need help urgently
[Edited on 13-01-2005 by topshot_2k]
[Edited on 13-01-2005 by topshot_2k]
|
topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
also does anyone have/know where i can get a diagram for wiring in a unichip into an x16xe ecu?
need to check everything electrical is ok before i can work these
faults out
|
broster
Premium Member
Registered: 6th Dec 02
Location: Drives: E39
User status: Offline
|
AHHHHAAAAA Aniother quad drive fault! i have it!
|
topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
lol, what is it?
do you have any other ideas on the other fault codes i got?
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
quad drive= bin ecu and get another one
|
topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
so ecu is screwed then? how much is new one with transponder?
so what about all the other sensors? are they faulty or is ecu dead?
|
Greasemonkey
Member
Registered: 17th Apr 02
Location: Drives a Tractor
User status: Offline
|
Speed sensor thing ignor because it just picks this up as the engine is not running when you did the test,
|
topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
ok the egr fault code is:
Linear exhaust gas re-circulation position (EGR)
could this be because my egr is wired in but blanked off?
|
Greasemonkey
Member
Registered: 17th Apr 02
Location: Drives a Tractor
User status: Offline
|
/\ yes
|
broster
Premium Member
Registered: 6th Dec 02
Location: Drives: E39
User status: Offline
|
quote: Originally posted by topshot_2k
so ecu is screwed then? how much is new one with transponder?
so what about all the other sensors? are they faulty or is ecu dead?
afraid so man! i got my omex to fit if it gets noticable.... new one cant be cheap!
|
Siberia
Member
Registered: 9th Oct 03
Location: Leprechaun Land Drives : Zafira GSI
User status: Offline
|
scrappers?
|
Greasemonkey
Member
Registered: 17th Apr 02
Location: Drives a Tractor
User status: Offline
|
£350ish new from vauxhall i belive, not many spare ones about as peeps usually take the engine with it. Could always borrom one and try it
|
ffls
Member
Registered: 29th May 02
User status: Offline
|
quote: Originally posted by topshot_2k
ok the egr fault code is:
Linear exhaust gas re-circulation position (EGR)
could this be because my egr is wired in but blanked off?
Just block the pipe that connects to the inlet manifold.Replaced my EGR and no more fault codes
|
topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
hmmm ok ill give it ago, only wanted to find out why it is idling all over the place but its the crankshaft sensor. but then got all these other faults come up!!!
i have an x14xe ecu would this work ok on my x16xe with unichip?
|
topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
broster you guna be slling your x16xe ecu?
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
quote: Originally posted by topshot_2k
hmmm ok ill give it ago, only wanted to find out why it is idling all over the place but its the crankshaft sensor. but then got all these other faults come up!!!
i have an x14xe ecu would this work ok on my x16xe with unichip?
plug it in and see
|
Greasemonkey
Member
Registered: 17th Apr 02
Location: Drives a Tractor
User status: Offline
|
it wont work due to the transponder chip thingy
|
topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
but i have the transponder key/chip so it should work ok with engine wont it?
|
broster
Premium Member
Registered: 6th Dec 02
Location: Drives: E39
User status: Offline
|
the engine wil lrun yes if you swap the key chip over.
|
broster
Premium Member
Registered: 6th Dec 02
Location: Drives: E39
User status: Offline
|
quote: Originally posted by topshot_2k
broster you guna be slling your x16xe ecu?
i lost the x16xe ecu. i have a mapped x14xe ecu in mine
|
topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
ok so if i put x14xe ecu in with unichip and get it mapped (does anyone kno anywhere good that can map unichips??) it should run fine?
|
topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
up, any other solutions before i work on it thursaday? things to try etc???
|
Siberia
Member
Registered: 9th Oct 03
Location: Leprechaun Land Drives : Zafira GSI
User status: Offline
|
i'd get just a standard ecu first and see if it idles ok.... then go about the unichip....
|