stevenford_uk
Member
Registered: 6th Dec 04
Location: Wrexham
User status: Offline
|
how much do you peeps think some 60mm nova gsi lowering springs would drop my corsa? (td cav lump)
do you think i would have any problems?
|
Joff
Member
Registered: 17th Oct 00
Location: Cambridgeshire
User status: Offline
|
What's the fascination with having cars so low they scrape the ground?
What size are your wheels?
[Edited on 10-02-2005 by Joff]
|
stevenford_uk
Member
Registered: 6th Dec 04
Location: Wrexham
User status: Offline
|
15's, i am goin euro style so need to go low as poss
|
stevenford_uk
Member
Registered: 6th Dec 04
Location: Wrexham
User status: Offline
|
i know it wont handle but since when does anyone buy a diesel corsa for perfromance, jus needs look good
|
Joff
Member
Registered: 17th Oct 00
Location: Cambridgeshire
User status: Offline
|
The car will be on the ground with 15s and -60mm anyway.
|
drunkenfool
Member
Registered: 7th Feb 03
Location: Hereford Drives: Audi R8 V8
User status: Offline
|
That was mine in the early days, lowered 60mm on 15s, wouldnt wanna go much lower!
|
stevenford_uk
Member
Registered: 6th Dec 04
Location: Wrexham
User status: Offline
|
i want lower than that really, but with me bein on et 37 wheels ya reckon i would get it or not? were they 60mm corsa springs or nova springs
[Edited on 11-02-2005 by stevenford_uk]
|
AdiSRI
Member
Registered: 1st May 02
Location: Berkshire
User status: Offline
|
wat width wheels with ET37, i dare say you will struglle a lot anyhoo going lower than that without coilovers...
|
stevenford_uk
Member
Registered: 6th Dec 04
Location: Wrexham
User status: Offline
|
they are 7.5" wide i think, ronal turbos.
15", i am goin beat the arches out to clear,
how ya reckon i could do te rears cos the inner arch meets the outer at the lip dont it.
|
AdiSRI
Member
Registered: 1st May 02
Location: Berkshire
User status: Offline
|
mines been bent front and rear for more room ,but it still catchs inside.
proper way is to split the inner and outer, move the outer as far as needed and then dd metal to bridge the hole created and reweld.
not a great pic, but u can see that i have plenty of room now, it was much closer to arch before
|
stevenford_uk
Member
Registered: 6th Dec 04
Location: Wrexham
User status: Offline
|
i aint havin any plastic bits, i am doin it with the metal, jus havin it smooth as fook, so u reckon, cut inner arch away, beat outer out enough and then weld inner back in where reqd
|
