large-sri
Member
Registered: 19th Feb 05
Location: Norv Davon (North Devon)
User status: Offline
|
hi, i got a x14xe. just done a pin test and the reading was 4,4.
this code states that the fuel mixture is to lean.
my question is:
if the fuel quantity is increesed will this change the idle speed, coz it runs at 750rpm.
it feels hesitant (flat) when pulling away from 1000rpm to 2500rpm but the ecu light comes on when im doing 70ish and about 4000rpm
any help welcome
cheers
large
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
fuel mixture is set by the ecu. probably a faulty reading from a sensor
i.e. coolant temp sensor, lambda sensor etc...
|
large-sri
Member
Registered: 19th Feb 05
Location: Norv Davon (North Devon)
User status: Offline
|
you are the don corsa808thanks to your advice this is starting to make sence, cheers mate
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
happy to help mate
a cts is £14 and a lambda sensor £20
these two are where id look first.
|
glennpanton
Member
Registered: 30th Jul 01
Location: west sussex
User status: Offline
|
most prob lambda sensor
|
Richie
Member
Registered: 3rd Dec 02
Location: Newport, Wales
User status: Offline
|
id say lambda too, doesnt kick in until the higher gears/revs when the engine is hot. The CTS would cause idling issues.
|
Mattb
Member
Registered: 2nd Feb 03
Location: Under your sisters bed
User status: Offline
|
or a split vacuum hose or an air leak somewhere (at least it dont cost anything to check these)
|
