rev1
Member
Registered: 1st May 05
Location: sheffield
User status: Offline
|
as a project for the winter i am thinking about puttin a 14 16v engine in a nova that ive seen cheap .what else would i need ?
mounts?
shafts?
wiring?
anything else?
any help appreciated thanks
|
rev1
Member
Registered: 1st May 05
Location: sheffield
User status: Offline
|
any1
|
rev1
Member
Registered: 1st May 05
Location: sheffield
User status: Offline
|
|
RCS
Member
Registered: 26th Jan 05
Location: Lichfield/Dundee
User status: Offline
|
Use Nova mounts, shafts, engine loom. Will need to convert it to MPi if its not already.
|
rev1
Member
Registered: 1st May 05
Location: sheffield
User status: Offline
|
any more info
|
CorsAsh
Member
Registered: 19th Apr 02
Location: Munich
User status: Offline
|
U2U Ojc, he did this...
|
RCS
Member
Registered: 26th Jan 05
Location: Lichfield/Dundee
User status: Offline
|
Does the Corsa have power steering?
|
James R
Member
Registered: 4th Feb 03
Location: 205GTi16/306GTi16
User status: Offline
|
you stripp off all the corsa mounts, use the corsa box on the engine, put on the nova mounts.
use th enova shafts
For wiring, you'll need to bore a 60mm (or abouts) hole on behind the battery to pass the loom in to the car.
Then you need the transducer and chip to wiring in to the car to turn off the immboliser. If it's a 1.2i then you'll need to put in a MPi fuel pump, form a vectra, astra etc, which needs abotu 4mm trimmign off the top.
Use the corsa cast upper nanifold, and use a nova GSi down pipe on a GSi system and you're away.
|