Ajones_17
Member
Registered: 20th Jun 02
Location: Sunny Wigan Drives: BLACK 03 VTS
User status: Offline
|
I decided to clean my engine yesterday and give it a blast with the jetwash, but i made sure i didnt actually hit anythin with a direct blast i just backed of a bit and used it as a spray. Problem is now when i put my foot down in my car it judders and wont accelerate properly. Any ideas guys?
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
It'll probably run through tbh mate
|
Phil W
Member
Registered: 1st Jul 05
Location: Shropshire Drives : Focus ST
User status: Offline
|
Water in the dizzy cap.
Take the cap off, and get some clean dry kitchen towels or something. Dab them in, dont rub them. keep dabbing until all the water is out then try again
edit, is there a dizzy cap on the 1.6 16v ?
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
quote: Originally posted by Phil W
Water in the dizzy cap.
Take the cap off, and get some clean dry kitchen towels or something. Dab them in, dont rub them. keep dabbing until all the water is out then try again
edit, is there a dizzy cap on the 1.6 16v ?
nop its a dispack engine
|
Ajones_17
Member
Registered: 20th Jun 02
Location: Sunny Wigan Drives: BLACK 03 VTS
User status: Offline
|
Here's a pic of my engine if it helps guys
You think it will just dry on its own then?
[Edited on 21-10-2005 by Ajones_17]
|
Iain M
Member
Registered: 18th Aug 05
Location: Wigan - Drives 272bhp corsa ZLET
User status: Offline
|
what type of paint and where you get it from to do the cover on your engine. I am doin mine red but i don't know what paint to use let us know. what mods have you done to the engine then mine looks the same but without the strut brace
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
leave it ticking over for a while then run it about, give it a good blast
|
Iain M
Member
Registered: 18th Aug 05
Location: Wigan - Drives 272bhp corsa ZLET
User status: Offline
|
what type of paint and where you get it from to do the cover on your engine. I am doin mine red but i don't know what paint to use let us know. what mods have you done to the engine then mine looks the same but without the strut brace
|
Iain M
Member
Registered: 18th Aug 05
Location: Wigan - Drives 272bhp corsa ZLET
User status: Offline
|
didn't mean to do that again
|
ShEp
Member
Registered: 9th Aug 05
Location: Dingwall, Highland
User status: Offline
|
leave it to run and dry off, i did this on mine, exact same engine, i steam clean mine quite often cos of the dirt and crap on the roads up my way, also check for water in the plus holes or a fecked lead,
|
Ajones_17
Member
Registered: 20th Jun 02
Location: Sunny Wigan Drives: BLACK 03 VTS
User status: Offline
|
Cheers lads, just use normal paint Iain mate its fine. I only fitted my strut brace yesterday, had it for ages though ll
|
Iain M
Member
Registered: 18th Aug 05
Location: Wigan - Drives 272bhp corsa ZLET
User status: Offline
|
the whole lot looks good mate might have a try this weekend. what prep work is needed or will the paint go straight on?
|
Ajones_17
Member
Registered: 20th Jun 02
Location: Sunny Wigan Drives: BLACK 03 VTS
User status: Offline
|
Cheers Iain mate, i used grey primer, some Gloss black, some Arden Blue, then laquered the lot, sorted
[Edited on 21-10-2005 by Ajones_17]
|
Iain M
Member
Registered: 18th Aug 05
Location: Wigan - Drives 272bhp corsa ZLET
User status: Offline
|
Thanx for the advice mate sort that out in my garage this weekend can you get the stuff from halfords then?
|
Ajones_17
Member
Registered: 20th Jun 02
Location: Sunny Wigan Drives: BLACK 03 VTS
User status: Offline
|
Yeah mate its just aerosol paint from halfrauds
|
langey
Member
Registered: 7th Sep 03
Location: Wigan
User status: Offline
|
jonesy the engine bay loks like the rest of the car
seen you on sainsburys the other night, was beeping at you from maccys as you went over the speed bump into sainsburys and on the way back out too, but you just pretended you didnt see me throught the bushs
dunno whats up with the car though hope it sorts its self out fella.
|
Ajones_17
Member
Registered: 20th Jun 02
Location: Sunny Wigan Drives: BLACK 03 VTS
User status: Offline
|
Didnt see you Langeth tbh, else i would have come over and demanded a go of the XE
Car seems to have sorted it self now
Strange
|
Kano
Member
Registered: 29th Aug 04
Location: Fife
User status: Offline
|
Itll be water down the plug holes.. Take the leads out and dry up inside the holes.. Done.. x
|
Iain M
Member
Registered: 18th Aug 05
Location: Wigan - Drives 272bhp corsa ZLET
User status: Offline
|
Managed to pain the engine on sat. i think it looks awsome. pictures will go on when ma and pa get back with the digital camera
|
dannycorsa c
Member
Registered: 8th Mar 03
Location: manchester (astley/tyldesley)
User status: Offline
|
probably a breather pipe come off some were. these engines have sooooooooooo many pipes its unbelivable. give everything a chack over for splits and stuff.
|
Ajones_17
Member
Registered: 20th Jun 02
Location: Sunny Wigan Drives: BLACK 03 VTS
User status: Offline
|
Its sorted now mate, thanks anyway lads
|