Gregor
Member
Registered: 28th Nov 03
Location: Paisley, Renfrewshire
User status: Offline
|
I am doing an engine swap from a 1.2 to a 1.6.I am looking for the imobiliser plug for the transponder,where abouts do I find it at the ignition barrel?
The starter motor is turning but the engine is not starting.Would the fact that the imobiliser is not plugged in be the reason for this?
Thanks
Gregor
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
if your car didnt have an immobiliser to start with there wont be any wiring for the transponder. you will have to retro wire it. Ive got a wiring diagram somewhere if you need it.
|
Gregor
Member
Registered: 28th Nov 03
Location: Paisley, Renfrewshire
User status: Offline
|
How do I do that ?
Straight to the fuel pump ?
|
Sly_SRi
Premium Member
Registered: 9th Apr 04
Location: Reading, UK Drives: Corsa C
User status: Offline
|
have you checked why the engine isn't starting? fueling, sparking ?
Corsa C Z20Let
Black Sleeper Turbo Project
|
ste_nova
Member
Registered: 8th Jan 01
Location: St. Asaph, N. Wales
User status: Offline
|
quote:
Originally posted by Dave A
if your car didnt have an immobiliser to start with there wont be any wiring for the transponder. you will have to retro wire it. Ive got a wiring diagram somewhere if you need it.
we had imob wiring on a 1.2i m plate we did... but no imob was fitted
|
Gregor
Member
Registered: 28th Nov 03
Location: Paisley, Renfrewshire
User status: Offline
|
Where did you find the wiring as mine is a 1.2i M Plate !!
|
Gregor
Member
Registered: 28th Nov 03
Location: Paisley, Renfrewshire
User status: Offline
|
ttt
Anyone know how to wire the immobiliser plug in ?
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
here you go mate, had to take a photo of it as the laptop wouldnt connect to the scanner.
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
ive also u2u'd you a written instruction of how to wire it in. might be usefull to post the u2u contents on here as well, I have deleted my u2u's so I cant post it myslf.
|
Gregor
Member
Registered: 28th Nov 03
Location: Paisley, Renfrewshire
User status: Offline
|
1. brown/red= input to alarm (not essential)
2. Brown blue= EM light on dash
3. unused
4. Brown= ground
5. black= ignition live
6. blue/red= from speed signal
7 blue red= to ecu
8. brown/white= diagnostic plug.
on the ecu connector in the footwell locate the thin blue/red wire and cut it. connect the end from the wiring loom from the clocks (i think you are using cable speedo do in this case this applies) to pin 6 then pin 7 connect to the ecu end of the wire that you have cut.
Cheers Dave cant thank you enough !
|
Gregor
Member
Registered: 28th Nov 03
Location: Paisley, Renfrewshire
User status: Offline
|
Done this tonight but still flashing light and not starting ?
Any ideas ?
|
