S.A Corsa
Member
Registered: 10th Jul 06
Location: N.M.E
User status: Offline
|
any one got any ideas on a upgrade the problem i have is, i have 2.016v breaks fitted with black diamond disks and pads i have bled them off ajusted hand break up etc etc but still crap, think it cud be master cylender there just not good enough iv recently upgraded engine further and am looking for some good stopping power any ideas peps p.s i have 15's on 16's are the biggest wheels im willing 2 fit
|
Cybermonkey
Member
Registered: 22nd Sep 02
Location: Sydney, Australia
User status: Offline
|
perhaps there is an airpocket
|
S.A Corsa
Member
Registered: 10th Jul 06
Location: N.M.E
User status: Offline
|
iv bleed them time and time again iv even left the top off over nite for all the fluid to drain out,then started from scratch, iv bledd them diagonal, str8, put new wheels cylenders on ajusted hand brake up still the same so i think its the scrappy 2day to get a new servo
|
EarlofBarnet
Member
Registered: 26th Mar 04
Location: West Cumbria
User status: Offline
|
Standard master cylinder could be fooked, do they feel spongey at all?
|
S.A Corsa
Member
Registered: 10th Jul 06
Location: N.M.E
User status: Offline
|
very spongey m8 iv been nd got new master and servo 2day i know its a common fault if there not bled right
|
S.A Corsa
Member
Registered: 10th Jul 06
Location: N.M.E
User status: Offline
|
bump
|
BaldScotsman
Member
Registered: 24th Jun 06
Location: Forfar Scotland
User status: Offline
|
ok wee tip for ye ,,,,,,,,,,,, let off yer handbrake adjustment ,,,,,,,,, then adjust up yer rear brakes ,,,,,,, have so ye can just feel the shoes binding , then hit wi a hammer ,,, when they run free but ye still hear em
(skiffing) then ye got em right ,,,, now adjust handbrake to 4 or 5 clicks
if that doesnt work ,,,,,, then ye need to try a re bleed ,,,,,,,,, a simple fix for this is ,,,,,, open a nipple at a time and let it run thru until no bubbles appear ,, then see how that goes 
|
|
