X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
Camber should not change on the back as there are no pivoting arms like wishbones create on the front. The camber is fixed on the rear beam, you can see it when you look at the arms that the drums connect to. The suspension isnt independant on the rear, unlike the front.
The camber will always remain at 1.5degrees.
If you put a wheel on that was 3ft wide for example, there would eventually become a point where the outside of the tyre isnt in contact with the road surface.
[Edited on 20-12-2006 by X 60RSA]
|
