vaux-tech
Member
Registered: 28th May 06
Location: Preston, Lancs. Drives: Astra SRI turbo.
User status: Offline
|
have a x16xe gsi, and bought a pvd bfo induction kit off ebay recently for it. now when i try to fit it, its a very,very tight fit and can only get it on about a centimetre or so, is it possible that this is for the c16xe and does the c have a slightly bigger inlet pipe size. any help appreciated.
|
vaux-tech
Member
Registered: 28th May 06
Location: Preston, Lancs. Drives: Astra SRI turbo.
User status: Offline
|
bump
|
eel
Member
Registered: 19th Oct 06
User status: Offline
|
it needs 2 b on there tight i have a pvd one on my corsa sri
|
vaux-tech
Member
Registered: 28th May 06
Location: Preston, Lancs. Drives: Astra SRI turbo.
User status: Offline
|
yes, but is it supposed to be so hard to get on? as i said, it will only go on about a centimetre or so. i think its for a c16 and not an x16. someone help?!
|
vaux-tech
Member
Registered: 28th May 06
Location: Preston, Lancs. Drives: Astra SRI turbo.
User status: Offline
|
come on peeps!!
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
spray some wd40 and push it on a bit harder.
|
vaux-tech
Member
Registered: 28th May 06
Location: Preston, Lancs. Drives: Astra SRI turbo.
User status: Offline
|
hehe, nice dave! gonna try different ways 2moz when fitted my depos.
|
ckallis500
Member
Registered: 14th Dec 04
Location: plymouth
User status: Offline
|
yeah c16xe inlet pipe is about a centimetre bigger than the x16xe inlet pipe... but the c16xe has an air flow meter so the filkter would fit the oposit way i.e it wont sit inside the platic pipe, it will fit over the air flow meter using a piece of rubber hose.. chris
|
