cdb gsi
Member
Registered: 15th Mar 07
User status: Offline
|
iv got corsa gsi c16xe and my pullys hav got sensor pickups,just had verniers deliverd and they dont hav sensor pick ups,can somebody tell if this is right and as any1 else done this,im puttin 270 fast road cams in can call me on 07984378058
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
the verniers wont run on standard ecu without the cam sensor lobes.
also, kent 270 cams wont go in without pocketing the pistons. well they will but the timing will need to be set miles out.
|
cdb gsi
Member
Registered: 15th Mar 07
User status: Offline
|
u can get pullys wiv sensor pick ups thou carnt u,there 270 piper
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
I managed to get some 270's into a x16xe. timing was so far out that it ran shite, need pocketed pistons to make the most of them. piper 264 is the biggest you can go without piston pocketing.
dbilas (from regal autosport) cam pulleys have the lobes on.
|
rallyjohn
Member
Registered: 1st Feb 03
User status: Offline
|
Use standard pulleys and remove pin from end of cam. When you have dialed the cams in then you can redrill through pulley and cam refitting the pin as removed earlier. Unlike verniers this method will not allow the pulley to slip, but its a bit more fiddly to do
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
and possibly destroy your engine while its on the rollers getting the cams dialled in
|
Robin
Premium Member
Registered: 7th Jan 04
Location: Northants Drives: Clio 182 Cup
User status: Offline
|
Fook doing that
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
theres no lugs on the 1.0/1.2 there just done up tight! but then again not quite as powerful!
|
