corsarob18
Member
Registered: 29th May 07
Location: north wheatley
User status: Offline
|
jus got a 4 branch manifold for my 1.2 8v corsa b! but there is no treaded hole for the lambda sensor?! should i jus discard the lambda sensor or try to bodge it in and fuck it up? suggestions appriciated!
|
B3KAN
Member
Registered: 15th Feb 07
Location: Inverness, Highland
User status: Offline
|
Drill a hold on the manifold and weld a nut in place then screw the lamba sensor in place 
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
drill a 14mm hole just after the primaries join, weld on a lambda boss and job done.
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
You may also need a new heated oxygen sensor.
As its a fair distance away from the head.
Normal sensors dont work well down there.
|
dan_c4rsa
Member
Registered: 12th Dec 06
Location: North Yorks Drives: MK3 Seat Cupra
User status: Offline
|
nah should be fine i reckon.
all ive done is what's been said. Got meself an alloy nut so it doesnt rust too much on the manifold. drilled a hole big enough for the lamba and welded it in place.
|
