dan_c4rsa
Member
Registered: 12th Dec 06
Location: North Yorks Drives: MK3 Seat Cupra
User status: Offline
|
any quick way of getting all my gears right on the linkage when attaching selector to gear stick arm?
I.e positioning before you tighten it up>
I can only get 2/3 gears each time. Just getting bored now.
|
carnuts
Member
Registered: 28th Aug 05
Location: Hertfordshire
User status: Offline
|
easiest way mate is to connect everything then get a 4.5mm drill bit go to the selector on the gearbox there will be a little plug whip that out and wiggle the drill bit in move the selector you will feel it move in a hold it in position then whip the clamp off linkage underneath
after that go inside the car there is the same size hole on your gear selector in the car do the same thing that will hold the gear stick then do the clamp back up in place it should now be in let the car down take the drill bits out give it a try and jobs a good un
|
yozzer2008
Member
Registered: 30th Dec 07
Location: stoke on trent .drives deisel corsa van ; )
User status: Offline
|
i did that trick on mine yesterday and it works mint
|
dan_c4rsa
Member
Registered: 12th Dec 06
Location: North Yorks Drives: MK3 Seat Cupra
User status: Offline
|
cheers. better than fucking trial and error lol.
will get it done tomorrow.
|