stewart_2004
Member
Registered: 1st Feb 07
Location: Teesside
User status: Offline
|
Hey Im having problems with my car again this time it seems to stall everytime I start it i have to keep my foot on the gas until it starts to get warm even then it sounds rough and then its fine after 5 mins I have changed the ICV but still the same The eml light was showing icv and map sensor voltage low. Its a 1.2 8v if that helps ?
|
Jonny 1.2 chipped
Member
Registered: 12th Apr 08
Location: Toton, Nottinghamshire
User status: Offline
|
ive got that same problem , but im going to take my k&n off and clean it and buy some carb cleaner and see what happens
|
stewart_2004
Member
Registered: 1st Feb 07
Location: Teesside
User status: Offline
|
I have removed my K & N and fitted the standard box it worked fine for months but now its done it again. I would try and fit the standard box mate and see what happens
|
Jonny 1.2 chipped
Member
Registered: 12th Apr 08
Location: Toton, Nottinghamshire
User status: Offline
|
cheers , will try it tonite , will miss the noise tho !
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
Drill some holes in the airbox below the filter then you will have your noise back.
|
Jonny 1.2 chipped
Member
Registered: 12th Apr 08
Location: Toton, Nottinghamshire
User status: Offline
|
ok , how many holes and how much noise will it make ?
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
Theres a guide on here somewhere mate, you'll have to search or check the tutorials section.
You want holes below the filter, to the side nearest the wing. DONT Drill holes on the engine side.
Dont go mad with the drill tho.
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
There are 2 guides in the tutorials section but unfortunately the pics have gone.
the more little holes create a raspy note.
the more big holes create a deeper note
|