FruitBooTeR
Member
Registered: 18th Jan 07
Location: Wolverhampton Drives: S15
User status: Offline
|
Im hoping this has happend to someone on here before.
Basicly at the side of the bumper you have te little sqaure things that push into a bracket on the wing of the car -
But one have mine has snapped, not completly but it doesnt support the bumper now it just comes out the bracket, leaving a gap like so -
And..
(Ignore missing arch haha)
Ive tried sealing the square back up using v strong stuff but doesnt seem to work
Anybody got any ideas or things that they did to bodge the bumper back on straight and fitting properly?
[Edited on 03-06-2008 by FruitBooTeR]
|
Richardhhha
Member
Registered: 29th Sep 07
Location: Croydon, Greater London
User status: Offline
|
aruldite? (sp) cant think of anything tbh im making something up for my gsi bumper to fix the clip that goes behind the arch trim... What have you been trying to use to attatch this lug?
|
FruitBooTeR
Member
Registered: 18th Jan 07
Location: Wolverhampton Drives: S15
User status: Offline
|
Well the sqaure thing is still attached as you can see in a pic its just v v weak so it bends when pushed in and so doesnt stay in the bracket.
Ive tried using araldite from b&q v stong and it seemed to work at one point but then it just came loose.
I can push the bumper into place using force but then when you let go it like pops back out, i cant think of anything to make it stay in as theres not much you can do with bumper on, and when its off the only thing to mess with really is that sqaure thing.
|
Envoy Ash
Member
Registered: 26th Nov 07
Location: west mids (stourbridge)
User status: Offline
|
sounds crap but is there no way u could get behind the wing and screw into that block from behind whilst u try sum kinf of adhesive.give it a good chance to set
mitre fix two part sray is very strong if u wanna try that.
[Edited on 03-06-2008 by Envoy Ash]
|
dean101287
Member
Registered: 22nd Jul 07
Location: Cardiff
User status: Offline
|
cant you fiberglass a block onto the bit where it should be then shape the fiberglass using a dremell or something
|
FruitBooTeR
Member
Registered: 18th Jan 07
Location: Wolverhampton Drives: S15
User status: Offline
|
Nahh i cant get behind the wing you can only access bracket when bumper is off
And as for fibre glassing, i dont think im that skillfull to do that tbh
Id rather take it to a bodyshop and see if they could do it.
|
FruitBooTeR
Member
Registered: 18th Jan 07
Location: Wolverhampton Drives: S15
User status: Offline
|
ttt need someone whos had this problem with a solution at hand
|
Richardhhha
Member
Registered: 29th Sep 07
Location: Croydon, Greater London
User status: Offline
|
if you fibreglass onto plastic the resin eats the plastic so you got to be very carefull.
|