Mistamist
Member
Registered: 16th Jul 03
Location: Gillingham, Kent
User status: Offline
|
does it matter which way round you connect these to the hard black pipe on the back of the engine??
|
Mistamist
Member
Registered: 16th Jul 03
Location: Gillingham, Kent
User status: Offline
|
anybody??
|
Rybo
Member
Registered: 6th Mar 08
Location: Cumbria
User status: Offline
|
i did the one off the side of the head to the passenger side heater pipe, the divers side off the right of the coolant gallery (black plastic pipe) and the bottom of the header tank off the left hand side of the coolant gallery (if you were to look at them head on from the back of the block)
at the end of the dat the two that go to the heater matrix shouldnt matter which way round they go as your only passing hot water through it for the blowers to blow accross- it just makes sense to put them this way round as you wont have to cross them over and space is pretty tight
|
Mistamist
Member
Registered: 16th Jul 03
Location: Gillingham, Kent
User status: Offline
|
nice one, i think thats where i have gone wrong. has been so long since i stripped it down thats the only thing i forgot. will give it a try today. thank you
|
DaveyLC
Member
Registered: 8th Oct 08
Location: Berkshire
User status: Offline
|
Shouldnt matter which way round you plumb them into the heater matrix its self as the water just goes round and back out again.,
|
Mistamist
Member
Registered: 16th Jul 03
Location: Gillingham, Kent
User status: Offline
|
all sorted now i ballsed up the pipework, corrected it now.
|
Rybo
Member
Registered: 6th Mar 08
Location: Cumbria
User status: Offline
|
good times
|