jonix
Member
Registered: 14th Apr 02
Location: South Bucks
User status: Offline
|
Hi,
Here's an opportunity to get hold of a second hand high torque exhaust manifold originally from BTB exhausts. It is about 2 and a half years old although has not been on a car for the last 6 months. At one point, one of the branches snapped off but this was repaired by Joe at BTB himself (see http://nojvad.com/~jon/manifold/PICT0007.JPG for repair).
It has whopping 1 1/8" downpipes and finishes at a huge 2.5" ideally suited to a complete 2.5" system but I also have an adaptor which will reduce the diameter to 2".
For pictures, see http://nojvad.com/~jon/manifold/
I am looking for offers over 200.
Cheers, Jon
[Edited on 21-02-2003 by jonix]
|
and-m
Member
Registered: 5th May 02
Location: Liverpool. Drives. Skud vRS.
User status: Offline
|
Give it a good clean, you may get more interest then??
|
jonix
Member
Registered: 14th Apr 02
Location: South Bucks
User status: Offline
|
The defect was a result of corrosion on the weld which finally came unstuck when doing an emergency stop. This problem was corrected with welding to re-attach it to the manifold. Twinned with a larger bore exhaust (2.5") and a highly tuned engine, it would certainly be a factor in increasing BHP.
However, that aside, people are welcome to make other offers.
|