Rob-e91
Member
Registered: 11th May 09
Location: South Wales
User status: Offline
|
Is anyone running them on there B on here atm?
the 16" ones? If so do they rub if you run 5 stud wheel adaptors?
Thanks
|
Nic Barnes
Member
Registered: 5th Apr 04
Location: nowhere near ginger people
User status: Offline
|
they will rub as you will dramatically change the offset. the offset on them as they are is good enough. convert your actual hubs to 5 stud to make them work properly.
|
Rob-e91
Member
Registered: 11th May 09
Location: South Wales
User status: Offline
|
Thought it might change to much. ok thanks nic
|
Nic Barnes
Member
Registered: 5th Apr 04
Location: nowhere near ginger people
User status: Offline
|
it would more than likely work on the front but id imagine hub converters are over 10mm thick, well id want them 20mm to get a good strong hold on a wheel bolt. which would mean they probably stick outt too far.
|
Gez G
Member
Registered: 12th May 04
Location: Glasgow
User status: Offline
|
Do it properly and convert the hubs.
|
Rob-e91
Member
Registered: 11th May 09
Location: South Wales
User status: Offline
|
The reason i was going to use adaptors is so that i could change back to 4 stud at anytime, easily.
|
Jake
Member
Registered: 24th Jan 05
User status: Offline
|
if you made 4x100 to vaaux 5 stud adaptors, there would be two holes that overlap. there are ways around this nowadays but alot of companies wont be able to make them
|
davieslim
Member
Registered: 15th Sep 08
Location: Glasgow City
User status: Offline
|
ive changed mines over with the 5 stud hubs etc and ive very little clearance so id say using an adaptor would cause you issues if you wanted the car lowered
|
Rob-e91
Member
Registered: 11th May 09
Location: South Wales
User status: Offline
|
how much is yours lowered m8 do they rub?
|
davieslim
Member
Registered: 15th Sep 08
Location: Glasgow City
User status: Offline
|
mines is 60mm front and rear and it doesnt rub but theres very little clearance between the wheel and arch as it is
|
