x14xe ry
Member
Registered: 11th Nov 08
Location: Gravesend, Kent
User status: Offline
|
fitting the clutch into the calibra (f18 box) when you tighten the presssure plate should the pressure plates release leaves move in when tighten the bolts
cheers ryan
|
Scotty C
Member
Registered: 6th Nov 05
Location: Kidderminster Drives: 1.6 16v Sport
User status: Offline
|
U mean the fingers? No they shouldn't.
|
x14xe ry
Member
Registered: 11th Nov 08
Location: Gravesend, Kent
User status: Offline
|
ok cheers mate would you no why they would go in once tighted?
|
Limecat
Banned
Registered: 25th Jun 05
Location: The Internet
User status: Offline
|
Yes they should.
|
x14xe ry
Member
Registered: 11th Nov 08
Location: Gravesend, Kent
User status: Offline
|
they should go in?
|
Limecat
Banned
Registered: 25th Jun 05
Location: The Internet
User status: Offline
|
Put the bolts through the pressure plate finger tight and they will stay still, work in a star type direction in stages upto the required torque setting, as more torque is applied the fingers will move. Make sure they are all at the same 'height'.
|
x14xe ry
Member
Registered: 11th Nov 08
Location: Gravesend, Kent
User status: Offline
|
we have done that but the clutch pedal is really low and but we cant get it back up to the right height really pluzzling any ideas?
|
Limecat
Banned
Registered: 25th Jun 05
Location: The Internet
User status: Offline
|
You do mean that the fingers move in towards the engine block and not in towards the gearbox bellhousing (shouldn't be possible) don't you?
What's the story, is it a simple clutch change or is it a transplant/box change etc? Do you know if the cable is ok? Selector fork etc? Did you do them to the specified settings?
When you say the pedal is low, do you mean where it physically sits within the cabin or where it bites?
|
x14xe ry
Member
Registered: 11th Nov 08
Location: Gravesend, Kent
User status: Offline
|
the fingers move in towards the engine block
well the gearbox was noise i forght it was the reease bearing so got the new clutch but turns out it is the gearbox that needs replacing i think the cable is ok seems ok
were going to check the selctor fork 2mora incase my dad put it in the wrong way
what do you mean by specified settings? followed the hayes manuel
the pedal is low physically sitting really low in the cockpit
|