Hodgy
Member
Registered: 29th Dec 09
Location: Felling, Tyne and Wear
User status: Offline
|
hi i have been on a few websites im after a x18xe1 clutch
but it only listed as a x18xe is the Diameter (216mm)the same size as the x18xe1 clutch
im unsure with it being a small block engine ???
or what other clutch would fit with the flywheel eg x16xe ???
[Edited on 05-10-2010 by Hodgy]
|
tom reid
Member
Registered: 8th Apr 04
Location: Nottingham
User status: Offline
|
You should have a pot type flywheel?, Iv'e just removed a clutch from one I have, I'm putting a flat flywheel on it, so the clutch is available , if you wanrt it? plenty of life in it yet.
|
