dalejones
Member
Registered: 9th Dec 08
Location: Swansea, Wales
User status: Offline
|
got all the engine in (c20xe corsa) and the linkage is all in place on the gearbox just need to attatch it to the car, just need to know how do you know when the gearbox is in neutral? so i can get in the car, put the selector into neutal and tighten up the bolt??
|
nad123
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 25th Jun 09
Location: south wales
User status: Offline
|
You need to twist the linkage coming out the box until the little pin with a spring on the gearbox presses in
|
dalejones
Member
Registered: 9th Dec 08
Location: Swansea, Wales
User status: Offline
|
hmmm quite unsure wot u mean, the pin that holds the linkage to the gearbox bit?
|
alan-g-w
Member
Registered: 9th Nov 07
Location: Glasgow
User status: Offline
|
this might help mate http://www.corsasport.co.uk/board/viewthread.php?tid=522108
[Edited on 06-11-2010 by alan-g-w]
|
markx14xe
Member
Registered: 5th Oct 08
Location: grimsby
User status: Offline
|
i found pinning the gear stick in the car to the left was to far over and was causing problems so, i made sure it was in the middle while i pin the linkage in place under the car tighten it all up now have all of mygears and reverse
|
dalejones
Member
Registered: 9th Dec 08
Location: Swansea, Wales
User status: Offline
|
hmm my box doesnt seem to have the pin with the spring on it! how else will i set it to nenutral?
|