antnee
Member
Registered: 30th Dec 07
Location: Cov Drives: Clio 197
User status: Offline
|
quote: Hi Anthony
I think the one way valve is actually inside (part of) the braided supply pipe.
I see what you are saying, in the photo its attached to the aluminium bend.
looking at the details, there is a number of ways to connect the feed. best is to connect directly to the inlet manifold, if this is not preferred it can be connected to the aluminium bend pipe as in the photo.
If connected to the aluminium pipe inlet, yes you would get a bit of bleed over, but given the pressure rating this wouldnt realy matter.
Looking at it logically, yes I suppose the best connection method would be to connect straight to the intake manifold.
Hope this helps.
Kind regards
Chris
Need4Speed
|
LeeM
Member
Registered: 26th Sep 05
Location: Liverpool
User status: Offline
|
He has no idea what he's going on about
|
ed
Member
Registered: 10th Sep 03
User status: Offline
|
People will buy anything. If this actually worked, then any high compression engine would melt and fall to bits with 25psi of boost.
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
cant see the air compressor filling quick enough....
oh and run 40psi if your engine can take it! wtf
|