Generation
Member
Registered: 7th Jul 09
Location: Essex
User status: Offline
|
OK, this has all been set up, I have gears
1
2
3
4
5
No reverse, reverse fails on the bulkhead, I was told I oculd bend this, by rmeoving a part so it fits. However I though while its removed I may aswell Buy a short shift, so I have.
How do I remov old linkage?
|
Ian
Site Administrator
Registered: 28th Aug 99
Location: Liverpool
User status: Offline
|
Jack the car up and also the engine, disconnect the shaft at the bulkhead and remove the pin through the coupling to the gearbox - will need battery etc. out of the way.
Remove the lower mount and it'll come out as one piece.
|
Generation
Member
Registered: 7th Jul 09
Location: Essex
User status: Offline
|
you need to remove an engine mount
Cheers mate, seems fairly staright forward
[Edited on 08-03-2011 by Generation]
|
Mike
Organiser: North West and North Wales
Premium Member
Registered: 20th May 06
Location: nr. Skipton, North Yorkshire
User status: Offline
|
You can get away with it on smaller engines but if you've got an X14 or X16 it'll be a lot easier dropping the mount, it's only three bolts
|
Generation
Member
Registered: 7th Jul 09
Location: Essex
User status: Offline
|
Should i/do I need to upgrade the bushes in linkage, while its out?
its an c20xe
[Edited on 08-03-2011 by Generation]
|
Mike
Organiser: North West and North Wales
Premium Member
Registered: 20th May 06
Location: nr. Skipton, North Yorkshire
User status: Offline
|
You don't need to but I'd advise the LMF nylon bushes, big difference compared to the standard items and for the sake of about a tenner you might as well why the linkage is off
|
Generation
Member
Registered: 7th Jul 09
Location: Essex
User status: Offline
|
http://www.lmfvauxhall.co.uk/M-Tech-Shift-Shortener-Nylon-Bushes.html
They the ones I take it, My short shife I got from ebay loks different, I asusme it all fits the same.?
Cheers Mike
|
Ian
Site Administrator
Registered: 28th Aug 99
Location: Liverpool
User status: Offline
|
Engine mount is no biggie, just have a jack spare to support the engine while it's off.
|
Mike
Organiser: North West and North Wales
Premium Member
Registered: 20th May 06
Location: nr. Skipton, North Yorkshire
User status: Offline
|
Yeah, they're the ones
The linkage in that pic isn't a Corsa one. The lower one in this pic is a Corsa linkage
|
