Jabba
Member
Registered: 27th Nov 09
Location: co.durham
User status: Offline
|
today i went to take the bungs out of the spare wheel well beacuse i was gona sand the little spot of rust down and primer it but when i took the bung out quite abit of the well came out with it and it did with all 4 bungs
so what im asking is what should i do with the spare wheel well as the car is far too good to scrap just need to sort that bit of rust out
should i
cut it out and get a new well
cut it out and just put flat sheet metal over where its ment to be
or what do people advise on doing
|
Mieran
Member
Registered: 28th Jan 08
Location: Newcastle upon Tyne
User status: Offline
|
Plate the holes is the easiest option, removing the whole well and plating it is a bit more work
|
john_redtop
Member
Registered: 31st Dec 08
Location: acklam middlesbrough
User status: Offline
|
as said just cut out the knackerd bits with a grinder and weld some new bits in
|
Jabba
Member
Registered: 27th Nov 09
Location: co.durham
User status: Offline
|
the thing is tho they whole well would need plating as the holes are quite big and the wells weak wich is realy weerd as the rest of the car is fine nice and strong
|
Mieran
Member
Registered: 28th Jan 08
Location: Newcastle upon Tyne
User status: Offline
|
Cut the well out and plate it with a flat sheet of steel then
[Edited on 21-03-2011 by Mieran]
|
brebaz
Member
Registered: 11th Dec 09
Location: newcastle
User status: Offline
|
Go to the scrappy look for a good nick one cut it out and operate on your 
|
Alex_Rally
Member
Registered: 6th Sep 09
Location: Tyne and Wear, gateshead
User status: Offline
|
flat sheet of metal mate then strap your spare wheel in the rear of car 
|
