nath2905
Premium Member
Registered: 6th Sep 10
Location: Staffordshire
User status: Offline
|
i'll try keep this short,
ive changed the engine, swaped loom, so ive had to connect the wires to the little black box in foot well, this is the result
no spark or fuel....
i have this box tool that i used to make a spark and work the dizzy to make sure the dizzy and arm worked correct, that resulted in a spark, so used that still no start, because of no fuel,
checked lines were on the correct way, they werent so swapped them, still no priming of pump on ignition or nothing, but if we earthed the relay (well think thats the way we did it) it primed, and checked it was at the rail and it was, turned over, but then the injector's didnt put any through, so we came up with it not been wired right or theres a broken wire,
this is what i have
corsa black block has...
Thick Red- connected
Thin Black- connected
Thin Green- connected
Thick Red Blue- connected to semi blue red correct?
Thin Red Blue- not connected?
Thin Brown Blue- not connected?
Thin Blue- connected
Thin Brown White- connected
Thin Brown Yellow- connected to one on blue connector correct?
Nova Gte Ecu has
Thick Red- connected
Thin Black- connected
Thin Blue- connected
Thin Green- connected
Thin White Brown- connected
Semi Thick Red Blue- connected
Other Blue Connector
Thin Brown White- not connected
Thin Yellow Brown- connected
Thin Red- not connected
Thin Brown- not connected
help on mistakes would help alot?
would save me calling electrician
thanks nath
|
