danbo
Member
Registered: 1st Jul 08
User status: Offline
|
hi ive got a quickshift for 1600 and i got the bushes elsewhere however they are nowhere near fitting. I can turn them down to fit but I wouldn't of thought it should've been a problem. Surely the buses should fit in a standard linkage and therefore other quickshift linkages as the holes would need to be the same as standard.
Anyone experienced this?
|
danbo
Member
Registered: 1st Jul 08
User status: Offline
|
up
anyone with quickshift linkage did you bushes fit straight in I dont know whether I should machine down or not?
|
Mike
Organiser: North West and North Wales
Premium Member
Registered: 20th May 06
Location: nr. Skipton, North Yorkshire
User status: Offline
|
Is it the nylon bushes you've bought? I think mine were slightly oversize, I just hammered them in and it stripped off any excess as they went in.
|
Nic Barnes
Member
Registered: 5th Apr 04
Location: nowhere near ginger people
User status: Offline
|
i had nylon ones on std linkage when i got a quick shift i had to persuade them to fit using a vice.
|
corsadonk
Premium Member
Registered: 4th Jul 09
Location: Marlborough, Wiltshire
User status: Offline
|
They are a tight fit, a bit of lube and hammer or vice will get them in.
|
Firefly
Member
Registered: 10th Aug 09
Location: Tasmania, Australia
User status: Offline
|
How much interferance is there? Should only be a maximum of maybe +0.002" or the hole in the bush will compress too much and need reaming out
|
