HarleyMK
Member
Registered: 17th Apr 11
Location: Milton Keynes Drives: Corsa Sport
User status: Offline
|
Right I've managed to snap my driveshaft on the gearbox side
It's snapped on the inner cv so it's just the inner cv left
Anyone got any ideas on how to get it out, I've tried everything and won't budge
Thanks
Harley
|
Generation
Member
Registered: 7th Jul 09
Location: Essex
User status: Offline
|
Pry bar
|
HarleyMK
Member
Registered: 17th Apr 11
Location: Milton Keynes Drives: Corsa Sport
User status: Offline
|
Tried it won't move 
It's well and truly in there
|
Root
Member
Registered: 28th Dec 08
User status: Offline
|
take off bit it's stuck in and then remove? or replace both bits
|
Generation
Member
Registered: 7th Jul 09
Location: Essex
User status: Offline
|
I had similar problem, although I didn't snap the driveshaft I pulled shaft to remove and it popped out of joint, so I had nothing to pull like you.
Got pry bar decent width, few taps with hammer and was out
|
Firefly
Member
Registered: 10th Aug 09
Location: Tasmania, Australia
User status: Offline
|
25x6mm steel flat bar 300mm long. I also knocked a few diff retainer teeth out especially for this purpose
|
Mr-SEH
Member
Registered: 10th May 10
Location: Dark places
User status: Offline
|
Or take off bottom gearbox plate 10 mil bolts and pop screw driver in there and push against Cv joint pops straight out. If your luck you won't have to replace the gasket
|
