jay.jay
Member
Registered: 28th Dec 10
Location: Gloucestershire
User status: Offline
|
Just put a rebuilt x16xe into my corsa to replace the x14xe that was in it. I've changed the ecu to a 1.6 one, and the loom and sensors are all the 1.4 ones. The engine misfires in low revs, almost like it's running too lean, and it also seems to bog down very slightly about 5000rpm too. On idle it seems to struggle very slightly. EML is on but it says crankshaft sensor, camshaft position sensor and knock sensor, but they were all working fine before the engine change?
Anyone got any ideas as to what could be happening? Don't really want to replace all the sensors if they haven't gone 
Thanks in advance
|
jay.jay
Member
Registered: 28th Dec 10
Location: Gloucestershire
User status: Offline
|
It's a long story, I had problems with the ecu when it first went in and it wouldn't drive at all unless the revs were 3k plus, I kno it's not good for it but I had to get home some how
|
