iby
Member
Registered: 14th Sep 12
Location: Lancashire
User status: Offline
|
Just went to get tracking done.
Guy points out a bearing issue on the left hand side, short shaft!
This is my second bearing, torqued up properly too.. Whats going on! Really frustrated! What do i do now? The wheel moves badly. Its not the discs or hub bolts or suspension, defo the bearing!
BEARINGS have been pressed properly.
The guy says it could be the shaft, is that true? If the cv joints in shafts are messed up, could that cause bearings to go?
big block shafts with big block conversion hubs.
[Edited on 04-05-2013 by iby]
|
davidm
Member
Registered: 21st Mar 11
User status: Offline
|
could be dodgy bearing.. try another one
|
one-mr-t
Member
Registered: 4th Aug 09
Location: Greater Manchester
User status: Offline
|
Check the flange hasn't worn down make sure it's a very tight fit
|
tobyc20xe
Member
Registered: 28th Jun 12
Location: bradford
User status: Offline
|
I would replace everything. New c.v,bearing and kuckle just to be on the safe side. Have the hub checked to make sure it's not bent ect.
|
monkeytwizzel
Member
Registered: 10th Aug 11
Location: Chard, Somerset
User status: Offline
|
One of the shafts sometimes needs the circlip groove moved to shorten it when using big block hubs or equal length shaft!
|
