Cruise corsa b
Member
Registered: 13th Jun 11
User status: Offline
|
I'm have difficulty wiring the loom into the existing wiring I've looked at threads and pictures and all I get every time I look at it is a headache if anyone has any advice or lives close enough that wouldn't mind helping with the wireing (£ of course) I'm located in London then let me know
Thanks
[Edited on 17-07-2013 by Cruise corsa b]
[Edited on 17-07-2013 by Cruise corsa b]
[Edited on 17-07-2013 by Cruise corsa b]
[Edited on 17-07-2013 by Cruise corsa b]
|
Walshyposse
Member
Registered: 9th Aug 10
Location: Wigan, Lancashire
User status: Offline
|
Alright mate most of the colours are colour to colour, on the 1.2 16v the ecu was near the inlet manifold.
The new wiring needs to go in the drivers side kick panel.
Colours are as follows:
Brown/yellow is diagnose
Brown/ white is diagnose
Brown/ blue is moronic light dashboard
Red is battery +
Green is rpm signal
Rd/blue is fuel pump
Blue is coolant temp
Black is switched live
Blue/green is oil pressure light
Blue white is alternator
Brown is earth.
These are what I used for my c20ne conversion, but I copied c20xe wiring so this is right for your car. Hope this helps mate good luck.
|
Walshyposse
Member
Registered: 9th Aug 10
Location: Wigan, Lancashire
User status: Offline
|
If your using a soldering iron it's a nightmare trying to solder some joints under the inlet manifold as there is no room whatsoever.
|
Cruise corsa b
Member
Registered: 13th Jun 11
User status: Offline
|
Ok mate thanks will have a look at this thanks again
|
Col004
Member
Registered: 25th Jun 03
User status: Offline
|
As Walshy says, Drag the wiring from the ECU near the inlet back into the car to the drivers kick panel and wire it as follows. dead easy mate.
|
