Jonny.N
Member
Registered: 10th Sep 08
Location: scotland
User status: Offline
|
Need little help. Start it in the morning. And go to pull away and it splutters and dies. Need to hold the accelerator down while cranking it over for it to start again. Runs a bit lumpy till its warm. Anyone any ideas ? Was thinking it's the cts sensor . ? Thanks
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
I'd change the CTS.
|
Jonny.N
Member
Registered: 10th Sep 08
Location: scotland
User status: Offline
|
Daft question. Where is it located? Thot it was the same as
X16xe. But it's not
|
gav93
Member
Registered: 27th Nov 10
Location: Bexleyheath Kent
User status: Offline
|
on the back of the inlet manifold, bit of a pain in the arse but with the right size spanner not too bad of a job
|
