andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
yea easy make sure the plugs on the loom your getting are the same colour as the one you have now were it joins the ecu
|
boz_gsi
Member
Registered: 12th Apr 07
Location: stoke-on-trent
User status: Offline
|
yer piss easy wont take long at all
|
alexroberts_12
Member
Registered: 7th Mar 10
User status: Offline
|
yeahh should imagne it taking about half an hour to be honest if its just engine loom  hope it works because i wana know whats gone now! :S lol good luck!
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
i wanted to smash it up. funny thing is though it ran fine for a couple of minutes then just started bogging down like a fucker again when you try to rev it up. gotta be loom related we tried everything else
|
jibjob
Member
Registered: 6th Apr 08
Location: Elworth, Cheshire
User status: Offline
|
Yup its the only thing left to do! The HT lead didnt help though 
|
KyleCorsa
Member
Registered: 6th Jan 09
Location: Wrexham (North Wales)
User status: Offline
|
My gf had exactly the same problem mate. I changed the MAP sensor, idle control valve plugs and leads and it didnt fix it. In the end it was the MAP sensor wiring. It had a cut/break in it as it must have burnt or cut on the back of the inlet. Took it to a garage and they fixed this and tuned it. Now it runs sweet as fella no more spluttering or misfires.
|
