RobHayes
Member
Registered: 6th Sep 03
Location: Lincolnshire
User status: Offline
|
i have one of these alpine digital amp thingys n it keeps cutting out when i turn it up. error code says that there is too much current. have tried replacing cable between amp and sub but no change. also think that one of voice coils in sub has gone but not sure if this could be the cause????
any help would be appreciated
cheers
|
corb
Member
Registered: 24th Apr 02
Location: Calgary, Alberta, Canada
User status: Offline
|
If one of your VC's had gone, youd know it, the sub would sound like it was 'farting' music.
|
Kris TD
Member
Registered: 25th Mar 02
Location: Ware, Hertfordshire
User status: Offline
|
have you got safe mode on by any chance?
|
RobHayes
Member
Registered: 6th Sep 03
Location: Lincolnshire
User status: Offline
|
safe mode aint on, have a dual voice coil sub but only had 1 wired up. have wired other 1 up n can go bit louder b4 it cuts off
|
RobHayes
Member
Registered: 6th Sep 03
Location: Lincolnshire
User status: Offline
|
sorted problem, sub was dodgy. have replaced wiv 2 12" n is fine. got no boot left tho
|