Davido
Member
Registered: 18th Aug 03
Location: Reading,Berks
User status: Offline
|
got my car up at min to sort rubbing out at back .....wheel catching lowered 60mm........got plastic arch off taken some of that away but its also catching the metal arch just wondering what and how to cut that back cheers??
was thinking maybe ppl have used dremmel?
|
infinitycorsa
Member
Registered: 3rd Apr 02
Location: Stourport-on-Severn, Hereford and Worcester
User status: Offline
|
with the rear arche m8 i just hammered mine out and puulled it out so to speak...if the offsets correct u shouldnt need to do much work....if you take the plastic off the rear arches becareful as if u hammer it out to much they wont fit on correctly
|
Davido
Member
Registered: 18th Aug 03
Location: Reading,Berks
User status: Offline
|
yeah got plastic of but didnt really want to hammer it has it sorted urs out?
|
infinitycorsa
Member
Registered: 3rd Apr 02
Location: Stourport-on-Severn, Hereford and Worcester
User status: Offline
|
well no because my offset is et 35 lol....but if urs is 48 or there abouts... u should be ok........just make sure there are no sharp edges !
|
Davido
Member
Registered: 18th Aug 03
Location: Reading,Berks
User status: Offline
|
et45
|
infinitycorsa
Member
Registered: 3rd Apr 02
Location: Stourport-on-Severn, Hereford and Worcester
User status: Offline
|
ttt in that case m8 hammer em out a bit with a rubber hammer
|
sperminator
Member
Registered: 31st Dec 02
Location: Newcastle
User status: Offline
|
right i have 16inch fondmetal alloys wiv a offset of 38, if i hammer the metal lip outwards and shave away etc will i be able 2 drop my car 60mm/50mm
|
Mo
Member
Registered: 29th Jan 03
Location: Bolton, Drives Q3 S-line +
User status: Offline
|
^^^^^^ then u won't be able to put the plastic arches back on
|
sperminator
Member
Registered: 31st Dec 02
Location: Newcastle
User status: Offline
|
why??
|
sperminator
Member
Registered: 31st Dec 02
Location: Newcastle
User status: Offline
|
well lets put it this way, What can i do so i can drop it 50/60 mm?? i dnt know where 2 start
|
Mo
Member
Registered: 29th Jan 03
Location: Bolton, Drives Q3 S-line +
User status: Offline
|
if u shave the arch too high you'll have a gap between the plastic arch and the bodywork.
|