Corsa E-Tec
Member
Registered: 4th Feb 04
Location: Stevenage Drives: Leon Cupra
User status: Offline
|
I tried to lower me car but then found i didn't have a 17mm deep for the top nut.
i was told that you need a special tool to hold the shock in place while you take the top nut off.
is this true?
im sure you can hold the top of the shock to stop it from spinning
|
littletriad
Member
Registered: 22nd Jun 03
Location: Oldbury, West Midlands
User status: Offline
|
No
|
DP.
Member
Registered: 21st Dec 03
Location: Stoke-on-Trent
User status: Offline
|
Yes
Use a deep drop 17mm ring spanner to undo the nut while you have a small spanner (i forget the size) on the top to stop the damper from turning.
|
dan.payne
Member
Registered: 19th Dec 03
Location: Whittington, Derbyshire
User status: Offline
|
its a 10mm small spanner and the 17mm ring spanner
|
Red_SXi
Member
Registered: 23rd Sep 02
Location: Dunstable Drives: 52 Plate BMW 3 M Sport Coupe
User status: Offline
|
The ring spanner has to have an offset tho, its called a swan neck. Took me fucking ages to find one for Paul's punto
|
BabyBlade
Member
Registered: 5th Feb 03
Location: Hereford Rides: Ninja 600
User status: Offline
|
yeah theyre hard to find, most people seem to find them in cheap tool sets so try your luck
|