Mistamist
Member
Registered: 16th Jul 03
Location: Gillingham, Kent
User status: Offline
|
Im getting 3 Lanzar Vibe 12inch subs 400w rms each,
i not too hot on ice so i need to know what sort of amp i should use to power these, not too expensive if poissible
also what is the best way to wire the subs up?
|
Richie
Member
Registered: 3rd Dec 02
Location: Newport, Wales
User status: Offline
|
Whats your budget and are they 4 ohm subs??
3 four ohm subs are a bit of a dodgy deal, best to go for either two or four subs when it comes to 4 ohm versions, so you get a total load of either 1 or 2 ohms.
|
johns purple beast
Member
Registered: 7th Nov 03
Location: herts
User status: Offline
|
where u getin these from m8 ???how much n are they any gd ???
|
Mistamist
Member
Registered: 16th Jul 03
Location: Gillingham, Kent
User status: Offline
|
heres the spec for the sub im getting
Blue Injected Polypropylene Cone, Non-Fatiguing Butyl Rubber Surround, Stamped Stell Basket w/Golden Terminal, 2inch High Temprature KaptonVoice Coil (4 Layer), 70 oz.Strontium Magnet Structure, Special Designed Rubber Magnet, Boot & Rubber Gasket Ring, 800 watts Maximum Power, 400 watts RMS, 4 Ohms Impedance
they 4 ohms each.
Budget of around £300,
could i get a 1200w digital monoblock and run all 3 from one channel?
[Edited on 02-06-2004 by mistdotcom]
|