Filby1
Member
Registered: 12th Dec 03
Location: Brighouse
User status: Offline
|
any way to alter the rear camber? on the B?
|
fragpot
Member
Registered: 29th Feb 04
Location: Linlithgow, West Lothian
User status: Offline
|
Yes, you need a cambershim... looks like
|
James R
Member
Registered: 4th Feb 03
Location: 205GTi16/306GTi16
User status: Offline
|
If you undo the stud axle to loosen it, then slide a bit of hack saw bladed snapped to the right length on the bottom and tigthen it, then you have abotu the right rear camber.
But not needed on a road car at all really.
|
Filby1
Member
Registered: 12th Dec 03
Location: Brighouse
User status: Offline
|
where do you get the shims from? and its really to stop the wheels catching the arch
|
ed
Member
Registered: 10th Sep 03
User status: Offline
|
Yea, but then you will wear your tyres un-evenly...
|
Filby1
Member
Registered: 12th Dec 03
Location: Brighouse
User status: Offline
|
i was told i could grind the nasty metal stuff that the wheels catching off, But im not sure about this bonding the arch back on stuff
|
ed
Member
Registered: 10th Sep 03
User status: Offline
|
I would trim the arches and bond the plastic back on before I would go changing the camber...
|
jamesw
Member
Registered: 28th Jun 02
Location: Station Town, County Durham
User status: Offline
|
where can you get these from could be interested in a set
|
