111RB
Member
Registered: 28th Mar 06
Location: newcastle under lyme
User status: Offline
|
Hi ive got a M reg corsa gsi (x16xe) was givin me the fault code TC92 hall sensor circuit and multec tc present ive replaced the cam sensor cleared the codes it runs fine but then when you cut the engine start it up again managment light cums back on and the code comes back. It runs/revs fine and does'nt go into limp mode any ideas????
|
Dean_W
Member
Registered: 13th Dec 05
Location: Downham Market, Norfolk
User status: Offline
|
If it's not in limp home it will be the EGR.
It's the most likely fault to cause this.
|
111RB
Member
Registered: 28th Mar 06
Location: newcastle under lyme
User status: Offline
|
thanks, I'll try that not had the car long the last owner tryed to do everythin himself so im just gonna have to try and put it all rite.
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
quote: Originally posted by Dean_W
If it's not in limp home it will be the EGR.
It's the most likely fault to cause this.
thats a load of bollocks. it probably will not be the egr, could be lots of things.
|