dave..GSi
Member
Registered: 8th Jun 06
Location: Aberdeen
User status: Offline
|
what do u need to do to fit morette headlights?
|
broster
Premium Member
Registered: 6th Dec 02
Location: Drives: E39
User status: Offline
|
a 8 mm spanner
|
dave..GSi
Member
Registered: 8th Jun 06
Location: Aberdeen
User status: Offline
|
i seen in the max power haynes manual it says u need to cut a bit of the bodywork off just under the headlight to fit??????
|
broster
Premium Member
Registered: 6th Dec 02
Location: Drives: E39
User status: Offline
|
nope
edit, depends hwere your fitting the indicators
[Edited on 13-06-2006 by broster]
|
RKS
Member
Registered: 2nd Mar 04
Location: Gloucestershire UK
User status: Offline
|
depends on where you are putting the indicators, if you put them in the bumper like in the max power book and in the position they did then you need to cut the crash bar
|
RKS
Member
Registered: 2nd Mar 04
Location: Gloucestershire UK
User status: Offline
|
lol u beat me to it broster!
[Edited on 13-06-2006 by --Rikki--]
|
LAMM13
Member
Registered: 15th Dec 05
Location: Towcester, uk
User status: Offline
|
iirc they fit a rs bumper kit aswell dont they?
|
jamesvalver
Member
Registered: 21st Feb 03
Location: Bury St Edmunds, Suffolk
User status: Offline
|
piece of piss to fit and wire up. i chose to put motorbike indicators behind the bumper mesh on me gf;s car
|
dave..GSi
Member
Registered: 8th Jun 06
Location: Aberdeen
User status: Offline
|
i think i will put the indicators in the fog lights could i do that its a gsi
|
jamesvalver
Member
Registered: 21st Feb 03
Location: Bury St Edmunds, Suffolk
User status: Offline
|
yeh its not a prob. just get a side repeater bulb holder and make a hole in ya foglight for it and use an orange bulb then just run 2 wires from the std indicator wiring to the side repeater in the fog
|