bigrabbelfast
Member
Registered: 18th Mar 06
Location: BELFAST N.I
User status: Offline
|
is there a trick to getting the 17mm nut off the bottom of the track rod end cuz the coonts just spinning the balljoint inside and i dont have an airgun
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
hammer a balljoint splitter between the track rod and the hub. then try and remove the nut.
|
bigrabbelfast
Member
Registered: 18th Mar 06
Location: BELFAST N.I
User status: Offline
|
good man i'll give that a bash now
|
valverguy
Member
Registered: 9th May 06
User status: Offline
|
get some heat on it if all else fails
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
If its being replaced anyway get the hacksaw out and cut the bolt off.
|