joes_1.4_16v_sport
Member
Registered: 15th Mar 07
Location: Preston, LANCS
User status: Offline
|
Underneath the car... 
If i wanted to change the note + sound (obv)...
What fitment is it? Ive curently got a magnex decat ---> powerflow centre+ twin 3.5inch rolled sqaure-ish tail pipe...
2.25in? Or am i best measuring +then going to get the pipe from B+Q // Wickes?
Where else could i buy some scafolding pipe from to replace my centre box?
Help wanted // apriciated
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Go to b&q for what??
You'll have to remove it and measure it to find the bore, it depends what you asked for at powerflow.
|
joes_1.4_16v_sport
Member
Registered: 15th Mar 07
Location: Preston, LANCS
User status: Offline
|
Bought the centre box / tail pipe from ebay at £100 3 months old// near brand new so fancy a change of exhaust noise t.b.h...
I love the tail pipe with the reiger rear bumper but just want it louder...
B+ Q for some pipe to replace the centre box!?
Where- else sells pipe aprox 2.5in bore? Im clueless t.b.h lol
[Edited on 25-09-2007 by joes_1.4_16v_sport]
|
Will94
Member
Registered: 1st Nov 02
Location: Nr. Ipswich, Suffolk
User status: Offline
|
measure the external diameter of ur centre pipe either side of the centre silencer, should be the same either side tho lol make sure u brush off any shite or rust 1st
Then head down to ur local exhaust supplier and say u need some mild steel pipe with internal diameter of what u jus measured.
Most places will sell it in lengths, so then jus cut off what u need and put some slits in it each end, cut out yer centre silencer, slip this bit over and clamp er up at each end.
Or weld it for a better and more permenant fit
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Need proper exhaust pipe.
Scaffold pole is too thick, and usually galvanised, which is very hazardous to weld/grind.
|
joes_1.4_16v_sport
Member
Registered: 15th Mar 07
Location: Preston, LANCS
User status: Offline
|
quote:
Originally posted by Will94
measure the external diameter of ur centre pipe either side of the centre silencer, should be the same either side tho lol make sure u brush off any shite or rust 1st
Then head down to ur local exhaust supplier and say u need some mild steel pipe with internal diameter of what u jus measured.
Most places will sell it in lengths, so then jus cut off what u need and put some slits in it each end, cut out yer centre silencer, slip this bit over and clamp er up at each end.
Or weld it for a better and more permenant fit
Cheers mate... Will ring kwik fit // national now + see what they have to say for themselves...
ALOT of money t.b.h. lol
|
