shauny bizzle
Member
Registered: 2nd Aug 06
Location: Sheppey, Kent Drives: Vectra GSI V6
User status: Offline
|
hi ive got a 95 plate corsa gsi, and its got leather seats but im on bout wiring the seats to be heated i know theres a couple of plugs that comes from the seats, how do i go bout wiring them in, ive been told the wiring is already there but where would it be? and where does the switchs go, where car i get the switches?
much appriciated
|
pow
Premium Member
Registered: 11th Sep 06
Location: Hazlemere, Buckinghamshire
User status: Offline
|
To check if you have the wiring, pull the slider cover off under the heater knobs and check for metal contacts in the slits in the boxes either side.
If you have the wiring, in each footwell:
Take off the kickpanel (Next to bonnet release) and loosen the door trims (T20 screws under lil flaps). Pull the carpet right up and out the way.
On the loom that runs directly infront of the seat, there will be a black connector taped up - this is the heated seat connector. Just cut the tape off by running a stanley knife along the plastic plug, work the plug free and pull (the rest of the wire/play in the cable will come free with a small tug!!).
Make a slit in the carpet to feed these connectors through, then plug the 2 pin plug dangling off the seat (sometimes it is tucked up with the foam in the bottom of the seat), pop the buttons in (tenner each from vuax) and order the CDX slidey thing cover with the hole already in (about £11) and voila!
heated seats!
|
|
