OliSteadman
Member
Registered: 14th Oct 07
Location: Barnsley
User status: Offline
|
As above need to wire my speedo in but needs to be retro wired as the engine clocks and gearbox are x16xe items and the car used to be a 1.4 8v with cable driven clock they are now electronic.
I know what each wire is:
Black- ignition live
Brown- earth
Red/Blue- Speedo sensor
I just need to know where each one actually goes
Any ideas
|
Torsa g
Member
Registered: 20th Sep 07
Location: Tamworth. Rides: An OSTRIDGE
User status: Offline
|
Where the speedo cable attaches onto the gear box you need to replace this with a tranducer, which will have the black,red and blue/ red wires coming out of it, take these wires upto the back off the dash then wire them into the back off the dash which should already have these wires on the block
cheers
|
OliSteadman
Member
Registered: 14th Oct 07
Location: Barnsley
User status: Offline
|
iv got the tranducer it has a brown black and red/blue coming from it, it doesn't have the wires coming from the plug as it used to be cable driven. So does all three wires go to the plug on the back of the clocks, if so which pins any1 know????
|
byrnie_2004
Member
Registered: 11th Mar 07
Location: Marple, Greater Manchester
User status: Offline
|
where can you get a transducer from?
is it a standard part on an electronic dash corsa? or is it aftermarket?
[Edited on 19-12-2007 by byrnie_2004]
|
luke85
Member
Registered: 26th Nov 07
Location: Chesterfield
User status: Offline
|
yeah a standard corsa one will do you, I bought mine new from vauxhall because it wasnt too expensive. youll need the plug to go into it from a scrap yard though
|
Richie
Member
Registered: 3rd Dec 02
Location: Newport, Wales
User status: Offline
|
You will need to run the red/blue wire to the back of the clocks... not sure what pin it is though.
|
