A1EX
Member
Registered: 29th Mar 00
Location: Turku, Finland
User status: Offline
|
On my missus' mums corsa shes got a locking wheel nut with thats round and got three holes in the middle and ive tried hammering a smaller one on and it just spins round is there any way of removing it?
|
jambo166
Member
Registered: 27th Nov 06
Location: WHITBY
User status: Offline
|
front or rear m8
|
A1EX
Member
Registered: 29th Mar 00
Location: Turku, Finland
User status: Offline
|
rear drivers side wheel
|
little_duke
Member
Registered: 21st Aug 06
Location: Tamworth,staffordshire Drives: rover coupe
User status: Offline
|
i had these on my 106
i had tro drill though the 3 holes and take the outer casing off,although if you get a 16mm socket and hammer it on it will lock on and spin it off
if not theres kits on ebay that removed them
|
jambo166
Member
Registered: 27th Nov 06
Location: WHITBY
User status: Offline
|
if its a rear 1 u can take the drum off and drill it owt i had 2 do this on my nova gud luck
|
A1EX
Member
Registered: 29th Mar 00
Location: Turku, Finland
User status: Offline
|
cheers, before taking the drum off and drilling ill try hammering a 16mm on
|
jambo166
Member
Registered: 27th Nov 06
Location: WHITBY
User status: Offline
|
quote: Originally posted by A1EX
cheers, before taking the drum off and drilling ill try hammering a 16mm on
best way m8 if all else falls then u can always weld a nut onto it just put a blob ov weld in the centre ov the nut
|