Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
first question, my electirc speedo ring doesnt fit over my new lsd, its too small??? anyone had this before?
secondary, the final drive doesnt slot on to the lsd, feels like it would need pressing or hammering on, is this right?
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
common problem with the speedo ring, which lsd is it?
final drives are sometimes a bit tight, put the final drive in a warm oven at 100 degrees for 30 mins and the lsd in the freezer for an hour, then assemble immediately. usually works.
|
gavin18787
Premium Member
Registered: 22nd Feb 05
Location: Basildon, Essex
User status: Offline
|
sounds like the assembally instuctions you get with the sbd rollers
Drives supercharged Tec with torque
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Most people with lsd's have an aftermarket electronic dash, so run the speedo off a magnet/sensor mount to the driveshaft/cv joint.
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
would rather use the standard sensor if possible
yes if does have a should on the lsd for something, but its just bigger than the standard one, same style
its a trans-x lsd
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
got a email back from chris ashley
says you cant use a vauxhall speedo drive
options?
|