ProjectNCK
Member
Registered: 22nd Oct 07
Location: Burnley, Lancashire
User status: Offline
|
About to buy some alloys , with the spec will they fit a corsa b
Tyre: 195 x 50 x 15
PCD: 4x100/4x108
Offset: 38mm
|
Terry12
Member
Registered: 24th Sep 07
Location: Manchester
User status: Offline
|
That offset is a little low bud. Is the car lowered?
Personally I never go below ET42.
|
ProjectNCK
Member
Registered: 22nd Oct 07
Location: Burnley, Lancashire
User status: Offline
|
not atm y luk better lowered ?
|
Terry12
Member
Registered: 24th Sep 07
Location: Manchester
User status: Offline
|
If the car is lowered you stand more chance of the wheels rubbing on the outer arch. I'm not used to Corsa's and wheel fitments but I see the tyres will be 195 so you may get away with it.
Personally I'd still try and get something with a higher offset as they are 49mm from factory.
Lower offset can cause tramlining especially when the car is lowered.
|
ProjectNCK
Member
Registered: 22nd Oct 07
Location: Burnley, Lancashire
User status: Offline
|
so without lowering shud be kk
|
Terry12
Member
Registered: 24th Sep 07
Location: Manchester
User status: Offline
|
I would imagine on standard ride height the wheels will fit and give you no rubbing issues. The 4x100 PCd will fit your hub so they will bolt on. Like I say you may have issues when/if lowering but you'll only know once lowered.
I'll be lowering mine by 60mm on the back with about a 41/42mm offset and may need to trim the bolts off the outer arches.
[Edited on 31-05-2008 by Terry12]
|