t.n07
Member
Registered: 16th Nov 07
Location: Bexleyheath, Kent
User status: Offline
|
My Clock/dash lights have come today and looked on tutorials for a guide on how to change then put can only find one for a post 97 corsa, mine is pre 97, pleeeease could someone dirrect me to the right page thanks !!!
|
t.n07
Member
Registered: 16th Nov 07
Location: Bexleyheath, Kent
User status: Offline
|
upp need help guys
|
Ellis
Member
Registered: 11th Sep 07
Location: Aberdeenshire
User status: Offline
|
As in MFD lights? And, dash lights around the heater controls etc?
|
t.n07
Member
Registered: 16th Nov 07
Location: Bexleyheath, Kent
User status: Offline
|
yes thanx
|
t.n07
Member
Registered: 16th Nov 07
Location: Bexleyheath, Kent
User status: Offline
|
found out how to do it, i have done the mfd lights but the centre consol is being a badger!!! i have undone the two screw behind the vents, two behind the heater slider, removed al heater switch thingy's, removed hazard warning button, and the front stilllllll wont come off please help im getting frustrated
|
t.n07
Member
Registered: 16th Nov 07
Location: Bexleyheath, Kent
User status: Offline
|
wooooohooo with a little bit of findling and jigling it come free looool but now i am having seriouse probs with the dials, i have followed the guide word to word, and its not working, i have undone all the screws but when i try to pull the dials free they just wont budge as if there is connections and cables behind any ideas...........
|
luke85
Member
Registered: 26th Nov 07
Location: Chesterfield
User status: Offline
|
If its a cable driven speedo you have to pull the clocks out a bit and reach up behind them to release the cable
|
t.n07
Member
Registered: 16th Nov 07
Location: Bexleyheath, Kent
User status: Offline
|
uhaaa yeah they are cable driven but then how would i get them back in lol thanks for help
|
luke85
Member
Registered: 26th Nov 07
Location: Chesterfield
User status: Offline
|
Its a bit awkward to reach up and press the clip to release it but just try to get a look up there and its not too bad. Its easier to clip back in than it is to get undone
|